Wuhan Jiusheng Welding and Cutting Equipment Co

Cutting torch
The power supply of this series of models can be equipped with various types of manual or motorized cutting torches. The interfaces of various cutting torches are consistent. You only need to align the copper interface of the cutting torch cable with the rear and front panel of the power supply. Just screw on the corresponding male threaded joint and tighten it. It must be noted that each interface must not leak water or air to ensure normal operation.
Motorized cutting torches are usually installed on CNC cutting machines, semi-automatic cutting machines or profiling cutting machines. At this time, you must pay attention to the installation firmly and require good insulation between the cutting torch shell and the clamping part at the clamping point. You can put a nylon ring with a diameter larger than the cutting torch on the outer diameter of the cutting torch to prevent the shell from breaking down during arc ignition< br/> (Air dry cutting) (For details on gas pressure setting, please refer to Chapter 4 - Operating Instructions, Article 1)
> Processing method
Cutting torch
Current specification
Electrode
/> Number
Nozzle
Number
Protective cover
Number
Center air pipe
Number
Copper jacket
Number
Vertical cutting

Gouging

In daily cutting, the degree of wear and tear of consumable parts in the cutting torch should be regularly monitored. Do not allow excessive wear of the electrode or nozzle in the cutting torch. If excessive wear occurs, Failure to replace it in time may cause the cutting torch to burn out. Generally, the electrode should be replaced in time according to the visual inspection of the concave point in the center. The nozzle replacement is based on the cutting quality requirements.
When replacing consumable parts and disassembling parts, special attention should be paid to the fact that the sealing rings at each part must not be damaged or missing to prevent air or water leakage.